Australian Monitor DigiPage - Manual (Page 8)

1 PROG 1 - 4 Input Section
LINE
MIC
PROG GAIN
The pair of RCA sockets accepts unbalanced line level inputs.
Stereo signals are internally summed to mono.
The XLR socket accepts balanced microphone level signals.
The trimpot controls the input gain of BOTH the balanced and
unbalanced program inputs. In a Master/Slave configuration,
these also control program linked inputs. (see Linking Section)
3. BACK PANEL
1
2 3
5
4a
8
6 7
PROG 1 PROG 3 PROG 2 PROG 4
PROG LINKS
MIC MIC MIC MIC LINE LINE LINE LINE
PROG PROG PROG PROG
GAIN GAIN
INPUT OUTPUT
GAIN GAIN
+
24V
DC
GROUND COMMON ALERT EV
AC
GROUND SUM
IN
RUN 1 RUN 2 RUN 3 RUN 4 DATA LINK
CAT 5 CAT 5 CAT 5 CAT 5
SUM TONE GEN
INPUT OUTPUT
LEVEL LEVEL
SLAVE
MASTER
ZONE OUTPUTS
+24V
POWER IN
VDC
8 7 6 5 4 3 2 1
ENGINEERED BY AUDIO TELEX COMMUNICATIONS PTY LTD SYDNEY AUSTRALIA
NOTE: If connecting to an unbalanced input, the negative pin (3) should not be
connected to ground but left floating.
2 ZONE OUTPUTS
There is a balanced XLR line level output for each zone.
NOTE: When operating as a slave unit, outputs labelled 1 to 8 will correspond to
zones 9 to 16, respectively. (see Linking Section)
8
4b
PIN 2
HOT
+
PIN 3
COLD
-
PIN 1
GND
FEMALE XLR
PIN 2
HOT
+
PIN 3
COLD
-
PIN 1
GND
MALE XLR
INSTALLATION SERIES
Australian Monitor