Australian Monitor DigiPage - Manual (Page 16)

6. LINKING TWO DIGIPAGEJr SYSTEMS
DigiPageJr is fully expandable to form a 16 zone paging system by the simple linking of two
units. One DigiPageJr is then designated the master unit, driving zones 1-8, with the other
slave unit driving zones 9-16. The following settings and connections are required to form a
linked DigiPageJr system.
The DigiPageJrM16 paging station must be used to access all zones. The DigiPageJrM8 can
also be used but will only access zones 1 to 8
This switches the unit from master (switch in) to slave (switch out). When set as master the unit
control zones 1 to 8. When set as slave the unit controls zones 9 to 16.
This link is essential. Use a pre-wired CAT5 patch lead.
The maximum cable length for the data link cable is 10m, but note that the PROG LINKS
cable length is limited to 0.5m (see below).
MASTER/SLAVE
This switch should only
be operated when the unit is powered off.
DATA LINK
NOTE: These are Ethernet connections. NOT
NOTE: Maximum data link cable length is 10m
Program Source Wiring
16
White/Green 1
Green 2
White/Orange 3
Blue 4
White/Blue 5
Orange 6
White/Brown 7
Brown 8
568A configuration
CABLE
PROG 1
PROG 2
PROG 3
PROG 4
NC
NC
GROUND
GROUND
INSTALLATION SERIES
Australian Monitor
NOTE: There are two series of DigiPage product available, the DigiPage and the
DigiPageJr. Use only DigiPageJr series paging stations with DigiPageJr and
only DigiPage series paging stations with DigiPage.