Australian Monitor DigiPage - Manual (Page 20)

20
8. ACCESSORIES
8 zone Paging Station Cat No. DPJR8M
16 Zone Paging Station Cat No. DPJR16M
Punch down tool Cat No. DPPDT
Black System Input Plate Cat No. DPRIPB
White System Input Plate Cat No. DPRIPW
Black Standoff surface mount Box Cat No. DPRMSMBB
White Standoff surface mount box Cat No. DPRMSMBW
Cat5 Cable tester Cat No. ATC-C5CT
NOTE: The paging stations for the DigiPageJr are different to the DigiPage and
cannot be mixed. The same applies to DPRM’s which cannot be used
with the DigiPageJr.
9. TROUBLESHOOTING GUIDE
Mains brownouts or incorrect
connection of devices may
cause processor to lock-up
Incorrect system gain
structure
Lack of system ground
Initailisation (boot) sequence
Cable too long
Cable fault
Station lock-up due to
connection while system is live
Cycle power on the DigiPageJr
-Check settings of all equipment
-Revisit Step-by-Step Setup Procedure
Normal operation when power
is applied
See Installation section
-Check cable.
-Check Paging Station with good cable at DigiPage
With all Paging Stations connected,
cycle power on the DigiPageJr
See Grounding in Installation
section
Likely Cause Remedy
Last station on run not
terminated Terminate the paging station.
See Paging Station on page 20
INSTALLATION SERIES
Australian Monitor
Emits high-pitch whine
Inconsistent operation
LED’s chase
No response to controls
Poor signal to noise ratio
DigiPage System
Trouble
Paging Station
All Call works but
Zone Page does not
Main unit set to slave
Set main unit master/slave switch
to master (switch in)
Paging locked up
Priority paging station in
CAT5 RUN2,3 or 4
Plug Priority paging station into CAT5 RUN1 only