Step – Edsal UR185-DW User Manual

Page 2

Assemble two (2) post with one (1) brace. Skipping one
slot from the bottom of the post (see figures A & B),
place the rivets into post with the slot pointing down,
and with the shelf ledge of the brace facing up, and tap
lightly to seat rivets (see figure A). Repeat with two (2)
post and one (1) brace. Assemble the two (2) post
units with two (2) beams (see figure C). Skip one hole
from the bottom of post, tap lightly to seat rivets. After
level is complete, add a laminate shelf.

Assembly Instructions for UR185DW

Take two (2) drawer mounts and insert the rivets skipping
one (1) slot hole down from the top of the post on both
sides of the unit. Take two (2) drawer slides, one (1) silver,
and one (1) black 31” Flat drawer braces. With the bend fac-
ing down, insert the rivets of the black brace into the slot and
half slot holes located on the back end of the drawer slides.
Insert the laminated shelf, and install the silver front drawer

brace to the front of the drawer slides. Install the drawer as-
sembly to the drawer mounts slides of the unit (see figure D).

IMPORTANT NOTE : Make sure all rivets are fully seated into the post slots.

Assemble the top post to the bottom post by using two
(2) beams and two (2) braces (see figure E). One (1)
rivet from each beam and brace must be placed in the
top slot hole of the bottom post, and the bottom slot
hole of the top post (see figure F). After all beams and
braces are in place, tap lightly to properly seat the riv-
ets.

Add a laminate shelf to the previously built level, and the
drawer. Continue by adding the third and fourth level to
the unit using two (2) beams and two (2) braces per
level. Tap lightly to properly seat rivets. Add the final
laminate shelves, and the handles to the drawers to final-
ize the assembly of the unit. Optional anchor hardware
is supplied with this unit so the unit can be fastened to a
wall if necessary.

Step

Figure A

Shelf Ledge

Post