Edsal 1LXD9 - Manual

Instructions : Welded Frame Instructions : Welded Frame Instructions : Welded Frame
In In In - - - Line Shelving Line Shelving Line Shelving
Should you have any comments, damage, missing parts, or problems with assembly of this unit please feel
free to contact our Edsal manufacturing facility at, (773) 475-3000 and request customer service.
To obtain replacement parts, please provide the following information :
- Model # - Part # & Description - Location Purchased - Date Purchased
General Instructions General Instructions General Instructions
Safety Instructions Safety Instructions Safety Instructions
Edsal Welded Frame In-Line Shelving unit is engineered to offer maximum flexibility as well as ease and
quickness of assembly. The rack units can stand individually, or for greater storage capability be joined together
using a common end frame. Individual beams can be adjusted without disturbing the beams in adjoining units.
These instructions should be followed exactly. All parts supplied must be used as shown. Any alteration or
deviation from this instruction sheet can result in unit failure.
This Welded Frame In-Line Shelving unit must be placed on a level surface. Failure to do so can result in unit
failure, poor product performance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE
THE UNIT AS A LADDER ! DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the
heaviest loads on the bottom shelf. Use care and the proper attire when working with metal parts.
Assembly Instructions Assembly Instructions Assembly Instructions
Attach the beams to the welded end frames as seen in figure 1. Use both welded end frames to establish the left
and the right sides of the units. After a beam has been placed to the end frame slots, tap down with a mallet to
help drive the beam end clip tabs into the end frame slots to secure the beam to the end frame (see figure 1).
Note: If the beam end clip tabs become bent due to mishandling. It may be necessary to adjust the tabs
back to their proper form. Steel shelving can now be added to each level to complete the unit. Each end
frame can be used as a common end to adjoin add on units for greater storage capacity. Extra levels can be
purchased to also expand storage capacity (see figure 2).
End Frame Slots
Industrial Products Division
Edsal Manufacturing Company
4400 South Packers Avenue
Chicago, IL 60609
www.edsal.com
Figure 2
Starter
Unit
Add-On
Unit
Example
Of Extra
Level
Model #’s :
1LXD3 - 1LXD4 - 1LXD5 - 1LXD6 -
1LXD7 - 1LXD8 - 1LXD9 - 1LXE1 -
1LXE2 - 1LXE3 - 1LXE4 - 1LXE5 -
1LXE6 - 1LXE7 - 1LXE8 - 1LXE9 -
1LXF1 - 1LXF2
Beam End
Clip Tabs
End Frame
Beam
Figure 1
Example of a
single straight
starter unit.
Example of a
double straight / tilt
starter unit.
Example of a
double inverted tilt
starter unit.
Example Of An
End Frame Used
As A Common
End, To Join Add
On Units