Edsal 7224PRB User Manual

Parts, Instructions : 7224prb

Instructions : 7224PRB

Bulk Storage Rack

Should you have any comments, damage, missing parts, or problems with assembly

of this unit please feel free to contact our Muscle Rack manufacturing facility at,

(773) 475-3000 and request customer service. To obtain replacement parts, please

provide the following information :

- Model # - Part # & Description - Location Purchased - Date Purchased

General Instructions

2 - Welded End Frames
6 - Beams
12 - Plastic Push Clips
3 - Particle Board Shelves

Parts

Safety Instructions

Muscle Rack Bulk Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly.
The rack units can stand individually, or for greater stability, be joined together using the common post. Individual
beams can be adjusted without disturbing the beams in adjoining units. These instructions should be followed exactly.
All parts supplied must be used as shown. Any alteration or deviation from this instruction sheet can result in unit fail-
ure. After the unit is assembled, it must be placed on a level surface for safety, and optimal product performance.

This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product perform-
ance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER ! DO
NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf. Use

care and the proper attire when working with metal parts.

Assembly Instructions

Made in China
Edsal Manufacturing Co., Inc.
Chicago, IL

Attach the beams to the welded end frames as
seen in figure 1. Use both welded end frames to
establish the left and the right sides of the units.
After a beam has been placed to the end units, tap
the beam down with a mallet to properly seat the
beam end clip tabs to the end frame post slots.
Note: If the beam end clip tabs become bent
due to mishandling. It may be necessary to
adjust the tabs back to their proper form.

Place a plastic push clip into the hole of the beam
end clip, then tap the plastic clip with a mallet to
drive it into the hole of the end frame post to se-
cure the beam to the end frame (see figure 1).

The completed unit should have three (3) levels
evenly spaced for maximum stability. Note: Al-
though the beams are adjustable in height, it’s
recommended to evenly space them so that the
stability of the unit is not compromised.

After all beams are in place, place the particle
board shelving to each level to complete the unit
(see figure 2).

Extra level kits can be purchased to increase
storage capacity. See your local Lowe’s retailer
to special order the extra level kits (SKU# 72BK).

Figure 1

Figure 2

Beam End
Clip Tabs

Beam

End Frame Post

End Frame Post Slots

Plastic
Push Clip

Particle Board Shelf