Edsal 1UFD1 - Manual

1/4-20 x 5/8”
Nuts, Bolts & Washers (16 ea.
Req’d)
*** IMPORTANT SAFETY INSTRUCTIONS PLEASE READ FIRST *** *** IMPORTANT SAFETY INSTRUCTIONS PLEASE READ FIRST *** *** IMPORTANT SAFETY INSTRUCTIONS PLEASE READ FIRST ***
When moving the cabinets on the dolly, always push from the sides of the cabinet. NEVER push from
the front, back, or top. This can cause a “tipping” hazard, which can result in a serious injury to your-
self or others. NEVER pull the cabinet during movement, push the cabinet to the location necessary.
Always move the cabinet over a flat level surface. Rough surfaces cause the cabinet to vibrate, which
causes the cabinet’s load to increase in weight, or again may cause a “tipping” hazard which can re-
sult in a serious injury to yourself or others. Always make sure when moving the cabinet the doors are
closed and locked. Doors may open and spill the contents inside. Also after movement, carefully open
the doors. It is possible that the cabinets contents may have shifted, and may fall from the cabinet.
Do not use this dolly for anything other than the manufactures intended purpose. NEVER stand on or
ride on the cabinet. Use the caster brakes to hold the dolly in position when it is stationary. DO NOT
OVERLOAD. Make sure items are evenly distributed on each shelf, and that the heavier items are
placed at the bottom. Do not store any items on the top of the cabinet during movement, this may
cause a “falling” hazard that can injure yourself or others.
Assembly Instructions Assembly Instructions Assembly Instructions
This instruction sheet was designed to help you assemble the dolly
in the proper way, please follow them using all parts and fasteners
provided. Any alteration or deviation from these instructions can
result in dolly and cabinet failure. After assembly is complete, make
sure the dolly is placed on a level surface as this may effect the per-
formance of the unit.
Place the dolly base on it’s side and align the brake and swivel
casters with the proper holes on the dolly base (see figure 1). In-
stall the 1/4-20 x 5/8” bolts through the dolly base and into the holes
of the casters. Apply the washers and nuts and tighten appropri-
ately (see figure 2). Turn the dolly right side up, lock the caster
brakes and place the cabinet into the dolly.
Should you have any comments, damage, missing parts, or problems with assembly
of this unit please feel free to contact our Edsal manufacturing facility at, (773)
475-3000 and request customer service. We can also be reached on the internet at
the following email address , [email protected]
To obtain replacement parts, please provide the following information :
- Model # - Part # & Description - Location Purchased - Date Purchased
Edsal Manufacturing
4400 South Packers Avenue
Chicago, IL 60609
www. edsal.com
CA5125R - Swivel
Caster (2 req’d)
CPDT3921 - 36 1/2” x 18 1/2” Tray (1 req’d)
Or
CPDT3927 - 36 1/2” x 24 1/2” Tray (1 req’d)
Caster Kit Caster Kit Caster Kit
Instruction Sheet Instruction Sheet Instruction Sheet
Figure 2
Figure 1
CA5125SB—Swivel Caster
w/ Brake (2 req’d)
Models DO3618, DO3624, Models DO3618, DO3624, Models DO3618, DO3624,
1UFC5, 1UFC6, 1UFC7, 1UFC8, 1UFC5, 1UFC6, 1UFC7, 1UFC8, 1UFC5, 1UFC6, 1UFC7, 1UFC8,
1UFC9, 1UFD1 1UFC9, 1UFD1 1UFC9, 1UFD1