Edsal ER247272PA - Manual

Instructions : Instructions : Instructions :
Welded Bulk Storage Rack Welded Bulk Storage Rack Welded Bulk Storage Rack
Should you have any comments, damage, missing parts, or problems with assembly of this unit please feel
free to contact our Edsal manufacturing facility at, (773) 475-3000 and request customer service.
To obtain replacement parts, please provide the following information :
- Model # - Part # & Description - Location Purchased - Date Purchased
General Instructions General Instructions General Instructions
Safety Instructions Safety Instructions Safety Instructions
Welded Bulk Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly. The
rack units can stand individually, or for greater storage capability be joined together using a common end frame. Indi-
vidual beams can be adjusted without disturbing the beams in adjoining units. These instructions should be followed
exactly. All parts supplied must be used as shown. Any alteration or deviation from this instruction sheet can result in
unit failure.
This Welded Bulk Storage Rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor
product performance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A
LADDER ! DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bot-
tom shelf. Use care and the proper attire when working with metal parts.
Assembly Instructions Assembly Instructions Assembly Instructions
Attach the beams to the welded end frames as seen in figure 1. Use both welded end frames to establish the left and
the right sides of the units. After a beam has been placed to the end frame slots, tap down with a mallet to help drive the
beam end clip tabs into the end frame slots to secure the beam to the end frame (see figure 1). Note: If the beam end
clip tabs become bent due to mishandling. It may be necessary to adjust the tabs back to their proper form.
Wire decking, or particle board shelving can now be added to each level to complete the unit. Each end frame can be
used as a common end to adjoin add on units for greater storage capacity (see figure 2).
Beam
Beam End
Clip Tabs
Figure 1
End Frame
End Frame Slots
Industrial Products Division
Edsal Manufacturing Company
4400 South Packers Avenue
Chicago, IL 60609
www.edsal.com
Starter Unit Add-On Unit
Figure 2
Model Shown With
Wire Decking
Model Shown With
Particle Board Shelving
Starter Model #’s :
ER247272WS - ER247272PS
Box Contents : 2 End Frames, 6 Beams,
3 Particle Board Shelves, or 3 Wire Decks
Example Of An
End Frame Used
As A Common
End, To Join Add
On Units
Add-On Model #’s :
ER247272WA - ER247272PA
Box Contents : 1 End Frame, 6 Beams,
3 Particle Board Shelves, or 3 Wire Decks