Edsal RSS6018 - Manual

Instructions : Heavy Duty Record Storage Rack Instructions : Heavy Duty Record Storage Rack Instructions : Heavy Duty Record Storage Rack
Should you have any comments, damage, missing parts, or problems with assembly of this unit please feel
free to contact our Edsal manufacturing facility at, (773) 475-3000 and request customer service.
To obtain replacement parts, please provide the following information :
- Model # - Part # & Description - Location Purchased - Date Purchased
General Instructions General Instructions General Instructions
Safety Instructions Safety Instructions Safety Instructions
Edsal Record Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly. The
rack units can stand individually, or for greater stability, be joined together using the common post. Individual beams
can be adjusted without disturbing the beams in adjoining units. These instructions should be followed exactly. All
parts supplied must be used as shown. Any alteration or deviation from this instruction sheet can result in unit failure.
After the unit is assembled, it must be placed on a level surface for safety, and optimal product performance.
This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product per-
formance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER !
DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf.
Use care and the proper attire when working with metal parts.
Assembly Instructions Assembly Instructions Assembly Instructions
Industrial Products Division
Edsal Manufacturing Company
4400 South Packers Avenue
Chicago, IL 60609
www.edsal.com
Figure 3
Starter Add-On
Figure 2 Particle Board Shelving
Attach the beams to the welded end frames as seen in figure 1.
Use both welded end frames to establish the left and the right
sides of the units. After a beam has been placed to the end
units, tap down with a hammer to help drive the beam end clip
tabs into the end frame post slots. To secure the beam to the
end frame, insert the plastic canoe clips through the hole in the
beam bracket and into the frame (see figure 1).
Note: If the beam end clip tabs become bent due to mis-
handling. It may be necessary to adjust the tabs back to
their proper form.
Attach the tie bars to the beams by inserting them into the slots
of the beams (see figure 1).
Particle Board Shelving can now be added to each level to
complete the unit (see figure 2). Each end frame can be used
as a common end, add on units can be purchased to expand
storage capacity (see figure 3).
Figure 1
End Frame Post
End Frame Post Slots
Canoe Clip
Beam
Tie Bar
Beam End
Clip Tabs
Model (s) : RSS6018 - RSS6036 - RSS7218 - RSS7236 - RSS9618 - RSS9636