Step – Edsal MR3600 User Manual

Page 2

Assembly Instructions for MR3600

IMPORTANT NOTE : Make sure all rivets are fully seated into the post slots.

Assemble the back panels using the nuts and bolt sup-
plied. Insert one (1) silver beam to the back top slots of

the posts, and place the back panels between the post
and over the beam. Continue by adding two (2) silver
beams even with the braces of the bottom levels. Add
one (1) black beam to the front of the unit placing the
bottom rivet into the top slots of the post. Assemble the

top post to the bottom post. One (1) rivet from each beam
and brace must be placed in the top hole of the bottom
post, and the bottom hole of the top post (see figure E).
Tap all beams and braces to properly seat the rivets.

Add wood shelves to the levels built. Align rivets from the
hinges of the doors to the sixth and twentieth post slots from
the bottom, and fasten the doors to the post. Install the
handle holder to the hole of the right door using the correct
orientation (see figure F). Install handle (in the vertical posi-
tion) through the holder. Place the nylon washer to the
back side of the handle followed by the nut, metal washer,
cam, and top washer. Fasten with the screw provided (see
figure F). Push the button and turn counter clockwise to
lock door. Add the final levels using the black beams and
braces. Add the final two (2) wood shelves to the unit.

Step

Figure D

Figure E

Wood shelves

RT. door

LT. door

Handle
hole

Hinges of door
fasten to post
slots six (6)
& twenty (20)
from bottom.

Figure F

Take one (1) silver brace, two (2) post, and one (1) side
panel. With the slot holes of the post pointing down, In-
sert the bottom rivet of the brace with the shelf ledge up
into the top slots of the post. Place the side panel be-
tween the post and over the brace (see figure A). Take
one (1) silver brace, skip one (1) hole from the bottom,
and insert rivets into slots of post (see figure B & C).
Count upward to the 13th, and 14th slots of the posts, and
insert rivets of the third silver brace. Making sure the
side panel rests evenly in-between the post (see figure B).

Step

Figure C

Note:
Post are
directional.
The slot
must point
down.

Post Slot Points Down

Figure B

Skip One (1) Slot