Edsal UR185 User Manual

Page 2

Assemble two (2) post with one (1) brace. Skipping one slot
from the bottom of the post (see figure A), place the rivets
into post with the slot pointing down, and with the shelf ledge
of the brace facing up (see figure B). Tap lightly to seat riv-
ets. Repeat with two (2) post and one (1) brace. Assemble
the two (2) post units with two (2) beams (see figure C). Skip
one hole from the bottom of post, tap lightly to seat rivets.

Assembly Instructions for UR

185, UR

245, & UR

Start by adding a woodboard shelf to the level previously
built, then continue working by adding the second level
using two (2) beams and two (2) braces in the post slots
of your desired location. Again place the rivets of the
beams and braces into the post slots with the shelf
ledge facing up and tap lightly to seat the rivets.

IMPORTANT NOTE : Make sure all rivets are fully seated into the post slots.

Add a woodboard shelf to the previously built level, then
assemble the top post to the bottom post by using two (2)
beams and two (2) braces. One (1) rivet from each beam
and brace must be placed in the top hole of the bottom
post, and the bottom hole of the top post (see figure D).
After all beams and braces are in place, tap lightly to
properly seat the rivets.

Add a woodboard shelf to the previously built level, then continue
by adding the fourth and fifth level to the unit using two (2) beams
and two (2) braces per level. Tap lightly to properly seat the rivets
and add the final woodboard shelves to the unit. Install all four
(4) end caps to the top of the unit after assembly has been com-
pleted (see figure E). Install end caps to post by pressing down
on end cap at the three points illustrated above (see figure F).

Step

Figure A

Figure B

Figure C

Shelf Ledge

Brace

Post

Woodboard Shelf