Edsal SB623034 - Manual (Page 4)

Assembly Instructions : Quick Assemble Bookcase Series Page 4 Assembly Instructions : Quick Assemble Bookcase Series Page 4 Assembly Instructions : Quick Assemble Bookcase Series Page 4
Step 5 - Shelf Assembly
First select a level for the shelf by selecting a set of
square notches located inside the unit on the back left
and back right sides. A series of round holes are located
on the inside of the left and right hand side panels near
the hinges. Using a shelf clip, insert the upper notch into
a round hole opposite the selected square holes where
the shelf is to be located. Push and “snap” the lower
notch of the clip into place using the next lowest round
hole. Repeat the shelf clip installation on the opposite
corresponding side. To insert the shelf, place the end
with the square cutout to the rear of the unit. Angle the
shelf so that the shelf will engage the square notches on
the back and lower onto the front shelf clips. Repeat the
process for all remaining shelves.
Figure 5 - Shelf Assembly
!
AFTER
ASSEMBLLY IS
COMPLETE :
SECURED TO A WALL
FAILURE to mount the unit to a
wall, can create a TIPPING HAZZARD.
A tipping hazard is dangerous to yourself, and
others. See your local hardware store to purchase
anchor hardware that properly suits the installation
of mounting this unit to a wall.
THE UNIT MUST BE
Drill two (2) appropriate hole sizes in the back of the unit
(hole size will vary based on type of hardware purchased).
Measure approximately eight (8) to ten (10) inches from the
side panel outside edge toward the inside of the back.
Measure approximately ten (10) to twelve (12) inches down
from the top. Where the two points meet, drill the first hole.
Repeat the process for the opposite side.
Fasten the unit to the wall using the hardware purchased
making sure the hardware is properly tightened and that the
unit now is secure. Use the illustration below for assistance
on proper hole placement.
Right Side
Left Side
Top
Hole Approximately:
eight (8) to ten (10)
inches inward from side
(opposite side also)
Hole Approximately:
ten (10) to twelve (12)
inches down from the top
(opposite side also)
Hardware through holes, and fastens to the wall
Wall
Note: Necessary Only For 72” & 84” Models
Back
Of Un
it