Goulds Pumps 3296M - IOM - Manual (Page 51)

47. Place frame horizontal and rebolt to workbench
(Fig. X).
l
! CAUTION
Do NOT hammer drive magnet assembly (740B)
on to shaft. this will damage ball bearings (112).
48. Place shaft wrench on drive shaft (122B). Torque
nut (355A) per Torque Table 12 in this section.
s
! WARNING
Use non-magnetic socket and extension wrench to
avoid personal injury or damage to parts.
49. Install one gasket (360W) in bearing frame.
Install rub ring (144A) so that the two milled slots
are at the 3:00 and 9:00 positions. Thread the rub
ring retaining screws (372Y) into each side of the
frame. Tighten screws ensuring they are fully
engaged into milled slots on rub ring (Fig. CC)
s
! WARNING
If rub ring retaining screws are not fully engaged,
ring may fall out during installation of adapter
assembly. This could cause personal injury and
damage to parts.
50. Install bearing frame jacking screws into bearing
frame (228) (Fig. DD).
s
! WARNING
When installing jacking screws make sure threads
extends a minimum of 8 inches beyond inside face
of bearing frame (228). Serious personal injury or
damage to the drive magnet assemble (740B) will
result if this is not done.
s
! WARNING
The magnets contained in this unit are extremely
powerful. Keep magnetic drive components and
magnetic tools apart from each other by a
minimum of six (6) feet [two (2) meters]. Serious
injury to fingers and hands will result.
3296 M Group 6/05
47
Eight
Fig. BB
Fig. CC