Goulds Pumps 3296M - IOM - Manual (Page 49)

s
! WARNING
Use non-magnetic socket and speed wrench to
avoid personal injury or damage to parts.
36. Install ball bearings (112) on drive shaft (122B)
(Fig. V).
NOTE: There are several methods used to install
bearings. The preferred method is to use an
induction heater that heats as well as de-
magnetizes the bearings.
37. Install inboard lip seal (333D) (Fig. W).
38. Bolt or clamp bearing frame (228) to work bench
(Fig. X).
39. Install drive shaft (122B) with ball bearings (112)
in bearing frame (228) as shown. The threaded
end of the shaft goes toward the magnets (Fig. Y).
NOTE: It may be necessary to lightly press shaft
with bearings into the bearing frame (228). It is
important to press the bearings in by putting a
sleeve on the inner race of the outboard ball
bearing.
3296 M Group 6/05
45
Fig. W.
Fig. X