Goulds Pumps 3296M - IOM - Manual (Page 38)

30. Bolt or clamp bearing frame (228A) to bench
(Fig. S).
31. Place shaft wrench on drive shaft (122B) and
loosen the drive magnet assembly hex nut (355A)
until it can be removed by hand. Leave nut on
shaft for now (Fig. T).
s
! WARNING
Use non-magnetic socket and extension to avoid
personnel injury or damage to parts.
32. Remove two rub ring retaining screws (372Y)
(Fig. U).
33. Thread two rub ring jacking screws into holes
provided in rub ring (144A) until they bottom
(Fig. U).
34. Tighten jacking screws until rub ring can be
removed.
35. Carefully invert bearing frame assembly, drive
magnet assembly up. Clamp firmly to work bench
(Fig. V).
s
! WARNING
This component can weigh more than 50 lbs (23
kg). Care should be taken when handling.
34
3296 M Group 6/05
Fig. S
Fig. T
Fig. U
Fig. R