Allied Telesis AT-2931SX - Manual (Page 54)

Installing Windows 2000 Driver Software
54
Modifying Configuration Properties
Although the default values should be appropriate in most cases, you can
change any of the available options to meet the requirements of your
specific system. After the adapter driver software has been installed, you
can use this procedure to verify or change the following adapter
properties:
ˆ “802.1p QOS” on page 55
ˆ “Checksum Offload” on page 56
ˆ “Flow Control” on page 57
ˆ “Jumbo Mtu” on page 58
ˆ “Large Send Offload” on page 59
ˆ “Locally Administered Address” on page 60
Configuring
Driver Properties
To configure the adapter properties, perform the following procedure:
1. On the desktop, right click My Computer.
The My Computer window opens.
2. Select Properties from the menu.
The System Properties dialog box opens, as shown in Figure 7 on
page 36.
3. Click the Advanced tab.
The Advanced tab is shown in Figure 13 on page 55.