Allied Telesis AT-2931SX - Manual (Page 24)

Installing the Hardware
24
Pre-Installation Checklist
1. Check that your system has an appropriate open PCI slot.
2. Verify that your system is using the latest BIOS.
3. Review the information in the readme.txt file on the CD-ROM for
important information not available at the time this manual was
created.
Note
If you acquired the adapter software on floppy disk or from the
Broadcom support website, enter the path to where the adapter
driver files reside on your system.
4. If your system is active, shut it down.
5. When system shut down is complete, power OFF and unplug your
system.
6. Holding the adapter card by the edges, remove it from its shipping
package and place it on an antistatic surface.
7. Check the adapter for visible signs of damage, particularly on the
card’s edge connector.
Never attempt to install any damaged adapter. If the adapter is
damaged, report it to Allied Telesis. See “Contacting Allied Telesis” on
page 14.