Allied Telesis AT-2931SX - Manual (Page 47)

AT-29xxSX Series Gigabit Ethernet Network Adapters Installation Guide
47
The System Properties dialog box opens, as shown in Figure 7 on
page 36.
4. Click the Advanced tab.
The Advanced tab is shown in Figure 12 on page 42.
5. From the Properties list, select Locally Administered Address.
6. From the Values list, assign a unique node address for the adapter:
ˆ The range is 0000 0000 0001 to FFFF FFFF FFFD.
ˆ Do not use a multicast address (least significant bit of the high
byte = 1).
ˆ Do not use all 0's or all F's.
7. Click OK.
8. If prompted to restart your computer, click Yes.
Even though it is not necessary to reboot the system for new adapter
properties to take effect, rebooting is recommended to reinitialize all
registers.
9. Verify that the adapter port LEDs operate as described in “LEDs” on
page 19.