Vaddio PresenterPOD System - Manual (Page 8)

PresenterPOD System
PresenterPOD System ● Document Number 342-0212 Rev. B Page 8 of 12
Installation (continued):
Sometimes, one PresenterPOD is just not enough. This is exactly the reason that one (1) PresenterPOD
Interface can support two (2) PresenterPODs. The 2-POD System (2nd Pod sold separately) is as easy to
connect as the 1st PresenterPOD. Connect PresenterPOD 2 in the POD 2 RJ-45 jack and connect the triggers to
the trigger device as noted in the previous example. When using two (2) PresenterPODs, dip switch # 9 ties the
logic of the PresenterPODs together in default mode (dip switch down) and they work as one system of eight (8)
triggers. By putting switch # 9 up, the pods act independently. When using one input triggering device like
AutoPresenter, ControlVIEW XHD Hot-Shot Preset Camera controller for codec, etc) the combined logic is
between the PODs is recommended (dip switch #9 down).
Basic System Connectivity Example 2:
This system configuration uses two (2) PresenterPODs and one PresenterPOD Interface to trigger the Vaddio AutoPresenter at two different
locations (Video Whiteboard and at the Instructor’s Lectern) in a presentation or videoconferencing room.
CeilingVIEW HD Document Camera
WallVIEW HD‐18AW PTZ Camera
Presenter Pod w/Mounting Tabs ‐
Whiteboard Location
HD Video
Presenter Pod at
Instructor’s Lectern
Location
Presenter Pod ‐ Interface
CeilingVIEW Quick‐Connect
RGBHV
Preset
Triggers
Quick‐Connect SR Interface
HD
Video
HD
Video HD Monitor
Squiggle Board
Cat‐5e
Squiggle Quick‐Connect Interface
Cat-5e
Cat-5e Cable up to 100’ (30.48m)
PresenterPOD 1 at Lectern
PresenterPOD 2 at Whiteboard
Cat-5e Cable up to
100’ (30.48m)
(Simulated VC Video Feed)
Laptop
Videoconferencing
Codec
Vaddio AutoPresenter
RS‐232
HD
Video
HD Video
RAR