Asus CUV266-DLS - Manual (Page 39)

ASUS CUV266-DLS User’s Manual 39
3. HARDWARE SETUP
Connectors
3. H/W SETUP
9) Infrared Module Connector (5-pin IR)
This connector supports an optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support
this feature. You must also configure the setting through UART2 Use Infrared
(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown in Back View and connect
a ribbon cable from the module to the motherboard SIR connector according to
the pin definitions. (NOTE: The SIR module does not come with the motherboard
package.)
10) Chassis Open Alarm Lead (4-1 pin CHASSIS)
Designed for chassis intrusion detection, this requires an external detection
mechanism such as a chassis intrusion monitor/sensor or microswitch. When
any chassis component is removed, the sensor is triggered and a high-level signal
is sent to this lead to record a chassis intrusion event. When not using the chassis
intrusion lead, place a jumper cap over the pins to close the circuit.
®
CUV266-DLS
0 1 0 1 0 1 0 1
CUV266-DLS Infrared
Module Connector
Standard Infrared (SIR)
Front View Back View
+5V IRTX
IRRX
(NC) GND
SIR
+5V IRRX IR
TX
(NC) GND
(NC) GND
CIRRX
CIR+5V
CIR
®
CUV266-DLS
0 1 0 1 0 1 0 1
CUV266-DLS Chassis
Open Alarm Lead
CHASSIS
+5V
olt
(Power Supply Stand By) Ground Chassis Signal
1