Pitco Frialator SRTG14-2 Dual Gas Rethermalizer - Manual (Page 22)

OPERATION
18 L20-291, rev. 1 (05/11)
Typical Retherm Times
Appliance Temperature
Product 140F 200F
Frozen 40 min. 9-10 min.
Thawed 30 min. 7-8 min.
This table is for reference only.
Please refer to the product
manufacturer’s specifications to
determine exact cook times.
2.4.4. ADDITIONAL CONTROLLER FUNCTIONS
Some controllers have additional functions not described in this manual. If your appliance’s
controller has additional functions, refer to the controller’s operation manual to access these
functions.
2.4.5. COOKING TIPS
 Always follow the food manufacturer’s directions and only use vacuum-sealed products in this
appliance.
 Some products can be reheated and held at the same temperature. If this is the case, the
product may be held in this appliance while still
in its vacuum-sealed bag. No separate holding
device required.
 Product bag size can be important in reaching
the shortest retherm times. Thin bags typically
retherm faster then thicker ones.
 Always allow a gap between product bags. This
will allow the hot water to circulate around the
entire surface of the product bag, creating good
heat transfer and ultimately shorter retherm
times.
 Do NOT retherm in boiling water. Boiling water increases your energy and water
consumption and furthermore this appliance is NOT recommended for boiling.
 Always follow proper food safety. Refer to FDA and the food manufacturer’s guidelines for
proper handling of the vacuum-sealed product.
2.5. APPLIANCE SHUTDOWN
There are two shutdown modes of appliance operation: STANBY and COMPLETE. The standby
mode removes the ability of the appliances main burners to operate. Complete shutdown turns off the
gas supply to the appliance. Refer to the following procedures to enter the appropriate shutdown
mode.
2.5.1. STANDBY MODE
1. If the appliance is equipped with a controller it should be turned OFF. If the controller has
an ON/OFF button, press and hold the button until the controller is off.
2. If the appliance is equipped with a I/0 (ON/OFF) switch, turn it to the 0 (OFF) position.
2.5.2. COMPLETE SHUTDOWN
1. If the appliance is equipped with a controller it should be turned OFF. If the controller has
an ON/OFF button, press and hold the button until the controller is off.
2. If the appliance is equipped with a I/0 (ON/OFF) switch, turn it to the 0 (OFF) position.
3. Turn the ON/OFF knob on the gas valve clockwise to the OFF position.
4. The appliance is now completely shut down and can be cleaned if desired.
OFF
ON
WARNING
NEVER leave the appliance in standby mode for prolonged periods or overnight.