Pitco Frialator SRTG14-2 Dual Gas Rethermalizer - Manual (Page 21)

SRTG: Gas Floor Model Rethermalizer
OPERATION
17
Maximum Recommended Product Capacity (after 195°F preheat)
2160 in³ Total (12x 180 in³ bags or equivalent) per tank
WARNING
Water must completely cover the heat
tubes at all times while appliance is on.
Typical Timer Buttons*
2.3. APPLIANCE START UP
Refer to the following procedure to start the appliance prior to operation.
1. Ensure that the drain valve is closed.
2. Fill the cook tank with water. (See section 2.1 “Filling the Appliance”)
3. Light the appliance. (See section 1.8.2 “Lighting Instructions”)
4. Turn the I/0 (ON/OFF) switch, to the I (ON) position.
5. The appliance’s controller may need to be turned on. Press the
* button to turn the
controller on.
*The specified button may appear slightly different then shown. Refer to the operator’s
manual for your appliance’s specific control type to determine the exact appearance of each
button and display.
6. The appliance is now on and heating the water
in the cook tank.
2.4. COOKING
It is important to keep the cook tank full of water to minimize the chance of boiling the appliance dry
and to keep the water at a level that will provide optimum cooking performance. To ensure the quality
of the food you cook in this appliance, follow the preparation instructions from the food manufacturer.
2.4.1. SIMMER MODE
Simmer mode maintains the water temperature to just below boiling. This mode is used to reheat
food or as a “stand by” mode. When the appliance is turned on, it will be in simmer mode.
2.4.2. BOIL MODE
Boil mode consistently heats the water so that the water will boil. Use of this mode is not
recommended for your appliance. Not all control types include boil mode.
2.4.3. TIMER OPERATION
Not all control types include timers. Timers provide accurate cook times for multiple product
quantities and types. Refer to the operator’s manual for your appliance’s specific control type to
determine how to set the cook timers if equipped.
To start a timer: Press the appropriate timer button.
*Timer buttons may appear slightly different then shown.
Refer to the operator’s manual for your appliance’s
specific control type to determine the exact appearance of
each timer button.
WARNING
NEVER operate the appliance with an empty cook tank. It may void the warranty.
Adding water after the heat tubes have been heated may cause injuries from hot
splattering liquids and steam.
WARNING
Dry fired heat tubes are extremely
hot, will shorten its service life
and may void your warranty.