Lyntec RPCM - Manual (Page 16)

139-0498-01.16
Chapter Five--Control Setup
16
Figure 5-3: Interface options
NetBios Name The NetBios name defaults to LynTecRPC. Each
master panel in your system should be assigned a
unique NetBios name. After names are assigned the
user can access the system web page by entering the
NetBios name into the web browser instead of using
the IP address.
Port Type
The port type section is used to select the preferred
communication protocol. The controller defaults to Ethernet
(TCP/IP) for setup but can be controlled in conjunction with
sACN or DMX-512 protocols.