CatEye CC-GL10 [Stealth 10] - Manual (Page 21)

21
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Others
Changing the computer con-
figuration
Uploading the mea-
surement data
Setup of your
PC
Changing the computer con-
figuration
6 Click on [STEALTH] to change the settings.
Before changing the settings, click on [Read] to load the settings of the computer.
Change the settings according to the following procedure.
Setting items Description
Time zone
Select the city code nearest from your current location.
* For details, see “Time zone list” (page 6).
Daylight saving
time
Select whether to use the daylight saving time.
• On : Moves the clock 1 hour ahead.
• Off : Displays in regular clock.
Speed unit Select the speed unit (km/h or m/h).
Night-time set-
ting
Set the time when the backlight lights up.
• Night-time setting ON :
Enter the start time when the backlight lights up.
• Night-time setting OFF :
Enter the end time when the backlight lights off.
(Example) When lighting up from 7:00 pm to 6:00 am
Night-time setting ON : 19
Night-time setting OFF : 6
* When you do not want to turn on the backlight throughout the day,
set the same value for both “Night-time setting ON” and “Night-time
setting OFF”.
Setting items Description
Tire circumference This is not used with this unit.
Total distance
You can enter the start value of the total distance, and add the trip
distance to it.
(Setting range : 00000 to 99999)
* This can be used when you renew and/or reset the computer.
* Enter the total distance in integer number only.
Sampling interval
Set the record interval of the measurement data.
* The maximum recording time (total time of all trip data) and the
maximum time for one trip depend on the interval selected.
• 1s (at intervals of 1 second) : 35 hours / 12 hours
• 2s (at intervals of 2 seconds) : 70 hours / 24 hours
• 5s (at intervals of 5 seconds) : 175 hours / 60 hours
Clock display
format
Select the display format of “12h” (12 hours display) or “24h” (24
hours display).
* Date and clock are acquired from GPS signal; therefore, it is not
necessary to enter them.
7 Click on [Apply].
The changes are reflected to the computer.
Remove the computer from the cradle. Now, changing the computer configuration is
completed.
Delete the data recorded
in the computer.
Read the current settings of the
computer.