Sony MZ-R900 - Manual (Page 65)

65
-GB
Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
BLANKDISC • An MD with no recording on it is inserted.
DISC ERR • The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. If this fails, rerecord.
DISC FULL • There is no more space to record on the disc.
, Replace the disc.
Data Save • The MD player is recording information (sounds) from the
memory to the disc.
, Wait until this process is completed. Do not expose the player
to any physical shock, nor disrupt power supply.
TOC Edit • The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the player
to physical shock, nor disrupt power supply.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
NAME FULL • You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names.
, Enter the characters within the limit.
Hi DC in • Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 55).
LOW BATT • Batteries are weak.
, Charge the rechargeable battery or replace the dry battery
(page 57).
MEM OVER • You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording again.