Sony DHC-MD595 - Manual (Page 51)

The MD Deck
—
Editing
51
7
Press – or + repeatedly to change the
Fade-in or Fade-out recording time.
The system plays the portion that will be
recorded over using Fade-in or Fade-out
Recording. You can set the time at any value
between 1.0 second and 15.0 seconds, in 0.1
second increments. You cannot set the time
longer than the track.
8
Press ENTER/YES.
“S.F Edit OK?” appears in the display.
9
Press ENTER/YES.
The deck starts recording over the existing
track. “S.F Edit: ** %” appears while the
track is being recorded. When the recording
finishes, “Complete!” appears in the display
for a few seconds.
To cancel the operation
Press MENU/NO in steps 4 to 8. If you press
ENTER/YES in step 9 and recording starts, you
cannot interrupt the operation.
Notes
• You cannot change the recorded level of a track
recorded in LP2 or LP4 mode.
• Do not disconnect the power cord or move the
system while recording is in progress. This may
damage the recording data preventing recording
from being performed properly.
• Do not use an MD that is damaged or dirty. This
may prevent recording data from being recorded
properly.
• Repeatedly changing the recording level results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it returned to the original level.
• The recording level cannot be changed while the
timer is activated.
• You cannot undo the S.F Edit Function even if you
use the Undo Function.