Sony DHC-MD595 - Manual (Page 33)

The MD Deck
—
Recording
33
5
Press – or + repeatedly until “T.Mark
LSync” appears, then press ENTER/
YES.
“L-SYNC” lights up.
6
Press MENU/NO.
To continue and record, follow the
procedures described on the various
recording pages.
To stop recording
Press x.
To change the trigger level for
automatic track marking
Do the procedure below to change the signal level
that triggers automatic track marking.
1 Press MENU/NO during recording pause.
“Setup ?” appears, then press ENTER/YES.
2 Press – or + repeatedly until “LS(T)” appears,
then press ENTER/YES.
3 Press – or + repeatedly to select the level, then
press ENTER/YES.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB steps.
4 Press MENU/NO.
To cancel automatic track
marking
Press – or + repeatedly until “T.Mark Off” appears
in step 5 above, then press ENTER/YES.
“L-SYNC” disappears. When “L-SYNC” is off, a
track number is marked only at the beginning of
each recording.
continued
4,5
3,6
2
1
4,5
4,5
1
Press FUNCTION repeatedly until
“AM” or “FM” appears.
To record from other components connected
to this system, select “TAPE” or “ANALOG
IN”.
2
Press MD z REC to stand by for
recording.
3
Press MENU/NO repeatedly until
“Setup Menu” appears.
4
Press – or + repeatedly until “T.Mark
Off” or “T.Mark LSync” appears, then
press ENTER/YES.