Sony ICD-BP150 User Manual
Page 9
9
GB
Replacing the batteries
The battery indicator on the display window shows the battery condition.
When
flashes, replace the batteries with new ones.
When
flashes, the batteries are exhausted and the unit will stop
operation.
Battery life*
With continuous use, approx. 10 hours (SP)/17 hours (LP) of recording or
approx. 7 hours (SP)/9 hours (LP) of playback is possible.
* Using Sony alkaline batteries LR03 (SG)
* When playing back through the internal speaker with VOL control at around 4
The battery life may shorten depending on the operation of the unit.
Notes
• Do not use manganese batteries for this unit.
• When you replace the batteries, insert the new ones within 3 minutes after you
removed the exhausted ones. Otherwise, the display may show the clock
setting display or incorrect date and time when you re-insert the batteries. In
this case, set the date and time again.
The recorded messages and alarm setting, however, will remain.
• When replacing the batteries, be sure to replace both batteries with new ones.
• Do not charge dry batteries.
• When you are not going to use the unit for a long time, remove the batteries to
prevent damage from battery leakage and corrosion.
Note on the “ACCESS” message
When you insert the batteries or disconnected the USB cable, “ACCESS” may
appear on the display window. Do not remove the batteries while this message
is displayed.
If the unit is required to process excessive amount of data, “ACCESS” may be
displayed for an extended period of time. This is not a malfunction of the unit.
Wait until the message disappears before starting operation.
Getting Started