Sony DSC-M2 - Manual (Page 93)

93
Tr
oubl
es
hoot
ing
Cannot print the image at the size selected.
• Disconnect the USB cable and reconnect it whenever you change the paper size after the
printer has been connected to the camera.
• The print setting of the camera differs from that of the printer. Change the setting of either the
camera (page 77) or the printer.
Cannot operate the camera after canceling printing.
• Wait for a while as the printer is carrying out the cancellation. It may take some time
depending on the printer.
Your camera does not work.
• Use the type of battery pack you can use with this camera (page 99).
• The battery level is low (The E indicator appears). Charge the battery pack ( t step 1 in
“Read This First”).
• Make sure that the AC Adaptor is connected securely.
• Properly attach the camera on the Cyber-shot Station (page 17).
The power is on, but the camera does not work.
• The built-in microcomputer is not working properly. Remove the battery pack, and then, after
one minute, insert the battery pack and turn on the camera. If this does not work, press the
RESET button with a fine-tipped object, then turn the power on again (This will clear the date
and time settings, etc.) (page 83).
Cannot identify an indicator on the screen.
• See page 18.
The lens gets fogged.
• Moisture condensation has occurred. Turn off the camera and leave it for about an hour before
using it (page 100).
The camera becomes warm when you use it for a long time.
• This is not a malfunction.
The Clock Set screen appears when you turn on the camera.
• Set the date and time again ( t step 2 in “Read This First”).
Others