AT&T E5908 - Manual (Page 45)

41
Answering System Operation
1.
Remote access
A two digit security code is required to access your
answering system from any touch-tone phone. This
code is 19 by default; see page 37 to change it.
Dial your telephone number from
any touch-tone phone.
2. When system answers, enter two
digit remote access code (
19
unless you have changed it).
3. Enter remote commands
(see list at right).
4. Hang up to end call and save all
undeleted messages.
Play all messages
1
Play new messages
2
Delete the message
3
33
Repeat or go back
4
Stop
5
Skip to next message
6
Record announcement
*7
to begin recording
5
to stop recording
Help menu
*5
Turn system off
0
Turn system on
0
Exit
8
Press to hear all messages.
Press to hear new messages.
Press during playback to delete current
message. Press
3 twice to delete all old
messages.
Press during the caller’s message to
repeat the message. Press during the
beginning of the day and time announce-
ment to go back to the previous mes-
sage.
Press to stop any operation (stop play-
back, stop recording).
Press to skip current message and
advance to next message.
Press * 7, wait for beep, then begin
speaking. Press 5 to stop recording and
hear playback of new announcement.
Press to hear list of features & com-
mands.
Press to turn off answering system.
Incoming calls will no longer be
answered.
If off, system will answer after 10 rings.
Enter your access code, then press 0 to
turn on.
Press 8 to end remote access call or
hang up.
NOTE: If you pause for
more than 4 seconds during
remote access, you will hear a
help menu listing all features &
commands. If you issue no
command for another 20 seconds,
the call will end automatically.
91-000646-010-000_E5908_R11.qxd 10/01/2006 6:10 PM Page 41