AT&T E5908 - Manual (Page 39)

35
Answering System Operation
Day and time announcements
To set day and time
Before playing each message, the answering system
announces the day and time the message was received.
Before using the answering system, you should follow
the steps at left to set the day and time, so messages
are dated correctly. If the clock is not set, before play-
ing messages, the system will prompt "Time and date
not set" each time.
The system uses voice prompts to guide you. Each time
you press
SKIP
or
REPEAT
, the day, hour, minute or
year increases or decreases by one. When you hear the
correct setting, press
CLOCK
to move to the next set-
ting.
To check day and time
You can press
CLOCK
at any time to hear the
current day and time without changing it.
NOTE: You can press and hold SKIP or REPEAT to increase or
decrease the minute or year by ten.
NOTE: Caller ID provides the time and date. Set the year so that the
day of the week can be calculated from the Caller ID information. After you
set the time once, it will thereafter be set automatically with incoming Caller
ID information. The time will be set automatically only if you subscribe to
Caller ID service provided by your local telephone company (see page 5).
1. Press CLOCK
The system will announce the cur-
rent clock setting, then announces
"To set the clock, press
CLOCK."
2. Press CLOCK
3. Press SKIP
or REPEAT
4. Press SKIP
or REPEAT
Press SKIP
or REPEAT
until the system announces the cor-
rect hour, then press CLOCK.
until the system announces the cor-
rect minutes, then press CLOCK.
until the system announces the cor-
rect day, then press CLOCK.
5.
6. Press SKIP
or REPEAT
until the system announces the correct
year, then press CLOCK. The sys-
tem announces the current clock set-
ting.
The system will announce the cur-
rent day setting, then announces
"To change the day, press SKIP
or REPEAT, to change the hour,
press CLOCK."
16
91-000646-010-000_E5908_R11.qxd 10/01/2006 6:10 PM Page 35