American Power Conversion VS 50 - Manual (Page 45)

Magnum VS –48 Vdc User Manual Page 45
6.4. Final Inspection:
5. Verify that the interior and exterior of the system is clean and free from debris.
6. Ensure all wires connected and bolts are properly tightened.
7. Ensure the following the User, Service, and Calibration parameters are set properly on the controller
(default settings are in parenthesis):
LVD
LVD1 Trip
LVD1 Reset
Battery Parameters
Discharge
Threshold
Float Voltage
Maximum Recharge
Compensation Method
8. Verify on the status menu that the system is functioning correctly with no alarms.
9. Be sure to leave the site as orderly and neat as possible.