elektraLite MY 250I - Manual (Page 14)

13
4. Press [ENTER] or [EXIT/DN] to exit.
- Tilt Reverse
This function reverses the Tilt movement.
1. Select
“rTIL” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” to enable this function or “OFF” if you don’t.
5. Press [ENTER] or [EXIT/DN] to exit.
- Switch 16 bit/8 bit
This function switches MY 250Ì from 16 bit to 8 bit resolution.
1. Select “16BI” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” to set 16 bit, or “OFF” to set 8 bit. The channels PAN Fine
and TILT Fine will be disabled.
4. Press [ENTER] or [EXIT/DN] to exit.
- Reset
This function resets MY 250Ì via the display panel.
1. Select “rEST” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” to enable this function or “OFF” if you don’t.
4. Press [ENTER] or [EXIT/DN] to exit.
- Restore factory settings
This function restores the factory settings of the device. All settings will be reset to the default values
(shaded). Any edited scenes will be lost.
1. Select
“LODA” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- Software version
This function displays the software version of the device.
1. Select “VER” by pressing [UP] button.
2. Press [ENTER], the display shows “V-X.X”, “X.X“ stands for the version number, e.g. “V-1.0”,
“V-2.6”.
3. Press [ENTER] or [EXIT/DN] to return to the main menu.
- Main menu 3
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “ADJU”.
- Lamp adjustment