elektraLite MY 250I - Manual (Page 11)

10
Main functions
-
Main menu 0
1. Press [ENTER] for 3 seconds to enter the main menu "MODE" (display flashing)
2. Press [ENTER] and select "ADDR", “RUN” or "DISP" by pressing [UP] button.
3. Press [ENTER] for selecting the desired sub menu.
- DMX address setting, Slave setting
- DMX address setting
This function, adjusts the desired DMX-address via the Control Board.
1. Select “VALU“ by pressing [UP] button.
2. Press [ENTER], adjust the DMX address by pressing [UP] or [DN].
3. Press [ENTER] to confirm.
4. Press [EXIT/DN] to return to main menu.
- Slave setting
This function, turns MY 250 into a slave.
1. Select “SLAV” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- No functions
- Program Run, Master setting
This function "RUN", runs the internal program. You can set the number of steps under Step. You can edit
the individual scenes under Edit. You can run the individual scenes either automatically (AUTO), i.e. with the
adjusted Step-Time or sound activated (SOUN). The selection "ALON" means Stand Alone-mode and
"MAST" means
MY 250Ì is the master.