To start a cycle – Alliance Laundry Systems TMB1276C User Manual

Page 13

Machine Cycle Definition and Operation

70444801

To Start a Cycle

1. Press the

keypad to change cycles.

2. Press the

keypad to move the cycle in the

right most menu box to the center, highlighted

position.

3. Press the

keypad to move the cycle in the

left most menu box to the center, highlighted

position.

4. Moving the

and

keypads allows the

selected cycle to scroll through the center,

highlighted position.

5. Press

to start selected cycle.

NOTE: Press and hold

keypad to

make highlighted area move rapidly.

NOTE: If door is not closed when the

keypad

is pressed, display will jump to the Close Door

Menu.

Every night at midnight the control will enter Service

Menu if the machine is in idle mode on the Cycle

Menu.
When a keypad is pressed or the door is opened or an

IR communication takes place, the control will turn

the LCD contrast on and the backlight back on (if

programmed).
Control will also enter specific service sub-menu for

that day.
Bi-Annual Menu displays on the last day of June and

December.
Quarterly Menu displays on the first day of the month

for January, April, July and October.
Monthly Menu displays on all other first days of the

month.
Daily Menu displays on all other days.

Press any keypad to clear the menu and return to the

Cycle Menu.
Optional settings are performed by either pressing a

keypad or by a combination of keypad presses:

 Press the

keypad to jump control to the

Contrast Adjust/Backlight Menu.

 Press the

keypad to enter the Service Menu.

 Press and hold

, then

enter the System Menu.

A Banner is displayed above the Cycle Selections in

the Cycle Menu. If Banner 1 and Banner 2 are

programmed, Banner 1 displays for ten (10) seconds

and Banner 2 displays for ten (10) seconds. If only one

Banner is programmed it will be the only one shown.

Refer to Banner Menu Section.
During communication with the PDA or network, all

menus enter IR Communications Menu.