Alliance Laundry Systems TMB1276C - Manual (Page 12)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 10 70444801
Machine Cycle Definition and Operation
There are 41 machine cycles that can be selected and
run. Machine cycles can be modified or made
“unavailable” by manually editing them in Modify
Cycle Menu or by using the PDA or network to
download a modified machine cycle into the control.
Machine cycles cannot be deleted, but can be made
“unavailable” so that they are not visible from the
Cycle Menu. New machine cycles cannot be created,
but existing machine cycles that have been edited to be
“unavailable” may be re-edited to be available again.
Machine Cycle Operation
When a cycle is run, the control runs the cycle
segment by segment in a sequence. First the control
examines the Cycle Type chosen to determine if it is a
Time Dry, Auto-Dry or Moisture Dry (if equipped)
cycle type. Then the first segment is examined to see if
it is programmed to “On” or “Off”. If the segment is
programmed to “Off”, control skips to the next
segment.
At the start of some machine cycles, the control
displays a Total Remaining Cycle time. This time is
taken from the machine cycles as they are
programmed. The Total Remaining Cycle Time begins
to count down as soon as the cycle is started.
Time Dry Cycle
In this type of cycle, the control will regulate the
temperature and time duration as programmed for the
cycle chosen.
Auto-Dry Cycle
If this type of cycle is selected, the control determines
the cycle time based on the temperature and dryness
level programmed for the cycle chosen.
Moisture Dry Cycle (if equipped)
In this type of cycle, the control checks the
programmed material type, programmed target
moisture content, programmed temperature and the
data received from the moisture sensing system to
achieve the desire results.
Rotation Sensor Equipped
Machines
On machines equipped with a rotation sensor, the
control monitors the rotation sensor to verify the
cylinder is rotating. The control calculates the
cylinder’s RPM. If the RPM drops to zero while the
cylinder is supposed to be rotating, the control will
advance to the Cool Down segment of the cycle and an
error message will be displayed.
Cycle Menu
The Cycle Menu is the first menu displayed by the
control after power-up. The Cycle Menu allows the
user to select one of the 41 machine cycles. Machine
cycles that are turned off will not be displayed on the
Cycle Menu. As a default, the last run cycle will be
displayed in the center, highlighted position. The
factory default cycle will be Cycle01.
TMB1301R
Figure 6
For Technical Service
Distributor ABC
1-800-555-5555
Cycle41:Five
Minute Low
Cycle02:
Sheets Blend
Cycle01:
Towels
Cycle Menu