Acer AIR-204 - Manual (Page 62)

A-2 User Guide for AIR-104/AIR-204
"Embedded HTTP server has been disabled. Only console can
configure the system"
The message is displayed when remote management has been disabled in the command
line interface. You will not be able to configure or view configuration from the HTTP
interface until remote management is once again enabled. You can only use a directly
connected console (PC running Hyperterminal) to run the Command Line Interface.
"Error: File Invalid"
The firmware file specified is either missing or invalid.
"Link is disconnected"
This message is displayed after disconnecting modem link operation is completed.
"Link is already disconnected"
This message is displayed when an attempt is made to disconnect an inactive modem
port.
"IP Address is invalid."
The IP address entered as the private address was not valid.
"Management session time out"
The message is displayed when HTTP or telnet management session is idle for more than
the default time out of 10 minutes, or the configured time out.
"Phone number limits characters to [0123456789,;-0]"
An invalid character has been entered in the phone number field. The acceptable phone
number characters are numbers from 0 to 9, and the characters "[" "]" "," ";" "-".
"Phone number seems to be incorrect"
The destination phone number is not correct or can’t be reached.
"Placing modem call. Please wait..."
The router is now in the process of contacting the remote site.
"Resetting system, please wait..."
The message is displayed when the router is in the process of resetting. You can logon to
the router after about 30 seconds.
"Save configuration succeeded"
The configuration was saved to flash memory successfully.
"Search fail"
An internal error has occurred.
Appendix A Messages