Diagnostic commands -5, Diagnostic commands, Chapter 7 command line interface – Acer AIR-204 User Manual
Page 46
7-5 User Guide for AIR-104/AIR-204
show dhcp
Description: This command displays the current status of the Dynamic Host Control
Protocol server.
Example:
Command> show dhcp
Admin Status: Enable Default Lease: 10 hours
Network address: 192.168.168.0 Netmask: 255.255.255.0
Default gateway: 192.168.168.207
Primary DNS: 199.191.129.139Secondary DNS: 199.191.144.75
IP-Address Mac-Addr Lease-Expires Entry Type
------------------------------------------------------------------------------------------------------------
192.168.167.134 00400535db4f 06-15-99 14:24:5 Static
192.168.167.229 222222222222 06-15-99 16:43:7 Dynamic
show dhcp table
Description: This command displays the entries currently configured in the Static DHCP
Assignment Table
Example:
Command> show dhcp table
Static Dhcp Assignments
Name IP-Address Mac-Address
----------------------------------------------------------------------------------------------------------
daniel 192.168.168.134 00-40-05-35-DB-4F
Diagnostic Commands
connect profile isp 1
connect profile isp 2
Description: For Internet profiles, this command activates the specified profile as if a
trigger occurred.
disconnect profile isp 1
disconnect profile isp 2
Description: For active Internet connections, this command terminates the connection as
if an idle timeout occurred.
enable/disable trace
Description: This command enables or disables the debug trace messages. When
enabled, all log messages entered into the system log will appear in the console session
from which this command is issued.
Chapter 7 Command Line Interface