Spektrum SPMAR6410 User Manual

Page 9

5. If you entered bind mode correctly, you will see a solid LED within about 10

seconds. You should now be bound to the transmitter and have full control and

function.

IMPORTANT: After Binding

Once the system is bound, the transmitter should always be turned on first and

then the receiver to prevent the receiver from re-entering bind mode. If your recei-

ver inadvertently enters bind mode, simply unplug the battery from the receiver and

reinstall with the transmitter remaining on.

Advanced Programming Features

The following programming features are only recommended for advanced radio

users. To safely accomplish advanced programming feature changes, please enlist

the use of a helper; one person to hold the aircraft to prevent unintended flyaways,

and a second person to make the changes on the transmitter. The procedures

below apply to all compatible transmitters. Prior to making any advanced

programming feature changes it is necessary to:

Computer Radios like the DX6i, DX7s

1. Choose an empty model location
2. Select model type ACRO
3. Perform a model reset
4. Set all channels to normal reversing
5. Ensure a successful bind has been established
NOTICE: All changes made in advanced programming must start with the receiver

powered down to prevent the motor from running unexpectedly.

Reversing Servos

Servo reversing may be achieved using the servo reversing function of your

transmitter, or as certain advanced applications require it, you may reverse the

actual servos by following the instructions and diagrams below.

Reversing The Servos on the Receiver Board

This feature reverses the servos at the board level, making it useful for

implementing features (such as elevons) when using transmitters with limited

programming options.

Sticks must be held in this position while the transmitter is on and the

receiver is off.

1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move control sticks to the corresponding position for the servo to be reversed

(see illustration).

5. While holding this position, plug the battery into the receiver; power on receiver

This manual is related to the following products:

SPMAR6410L