Spektrum SPMAR6410 - Manual (Page 14)

EN
14
Problem Possible Cause Solution
LED on receiver
flashes and aircraft
will not bind to
transmitter (during
binding) Transmitter too near
aircraft during binding
process Power off transmitter, move
transmitter a larger distance
from aircraft, disconnect
and reconnect flight battery
to aircraft and follow
binding instructions
Bind switch or button
not held long enough
during bind process Power off transmitter and
repeat bind process. Hold
transmitter bind button
or switch until receiver is
bound
LED on receiver
flashes rapidly
and aircraft will
not respond to
transmitter (after
binding) Less than a 5-second
wait between first
powering on transmitter
and connecting flight
battery to aircraft Leaving transmitter on,
disconnect and reconnect
flight battery to aircraft
Aircraft bound to
different model memory
(ModelMatch
TM radios
only)
Select correct model
memory on transmitter and
disconnect and reconnect
flight battery to aircraft
Flight battery/
transmitter battery
charge is too low Replace/recharge batteries
Control surface
does not move Control surface, control
horn, linkage or
servo damage Replace or repair damaged
parts and adjust controls
Wire damaged or
connections loose Do a check of wires and
connections, connect or
replace as needed
Flight battery charge
is low Fully recharge flight battery
Control linkage does
not move freely Make sure control linkage
moves freely
Controls reversed Transmitter settings
reversed Do the Control Direction
Test and adjust controls on
transmitter appropriately