Spektrum SPMAR6410 User Manual

Page 11

To Change Channel 6 to a Reversed Channel 2 for Dual Ailerons

or Reversed Channel 2 to Channel 6

Sticks must be held in this position while the transmitter is on and the

receiver is off.

1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move Control sticks to the corresponding position to change between the

available options (see illustration)

5. While holding this position, plug the battery into the receiver; power on receiver
6. The LED on the receiver will go solid and within 5 seconds, the LED will flash 3

times quickly, indicating the option is now changed

7. Disconnect flight pack from receiver
8. Turn transmitter off

Mode 1

Mode 2

To Change the Brushed Motor to Operate an Optional Brushless Motor

ESC or Brushless to Brushed Motor Control

The AR6410/AR6410L is capable of operating brushless motors with the use of an

optional brushless ESC, please see the illustration below for instructions.

Sticks must be held in this position while the transmitter is on and the

receiver is off.

1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position (see illustration)
4. Move Control sticks to the corresponding position to change between the

available options (see illustration)

5. While holding this position, plug the battery into the receiver; power on receiver
6. The LED on the receiver will go solid and within 5 seconds, the LED will flash 3

times quickly, indicating the option is now changed

7. Disconnect battery from receiver
8. Turn transmitter off

Rev. CH2/CH6

1. Full THRO

2. Up ELEV

3. Left AILE

THRO/RUDD ELEV/AILE

ELEV/RUDD THRO/AILE

This manual is related to the following products:

SPMAR6410L