Spektrum SPMAR6410 - Manual (Page 7)

EN
6 7
AR6410/AR6410L Features and Ports
Receiver Installation
It is recommended to use double-sided foam tape strips and/or minimal hot glue
in the corners to install your receiver in the fuselage. The servos need to be in
the appropriate position to attach to and drive the elevator and rudder pushrods.
Installation will vary depending upon application.
Servos
The AR6410/AR6410L incorporates integrated servos, but optional Spektrum
servos are also available. Using any servo other than a Spektrum servo will cause
damage to the receiver and/or the servo and may void the warranty.
Antenna
Rudder
(CH4) servo
X-Port (all 4 pins)
OR Gear (CH5)
(lower 3 pins)
Aileron (CH2)
Battery input
Reversed Aileron
(CH2) or Aux1 (CH6)
Elevator (CH3)
servo
Brushed Motor output
(– + open)
– + open
+ –
ESC Brushless
(signal + – )
Optional servo