Spektrum SPM20310 DX3.0 - Manual (Page 27)

Accessing the
Direct Trim
Mode
The Direct Trim Mode function of the DX3.0 is accessible through the use of the electronic
throttle or steering trim levers, as well as the two electronic grip levers (A&B) located on
the upper portion of the grip handle. This function allows for quick trim adjustment of these
controls.
To access the Direct Trim Mode function, turn the transmitter power switch on. Next, move
the desired trim lever to be adjusted. The appropriate screen for the selected trim lever will
be displayed. To adjust, simply move the trim lever in the desired direction until the correct
amount of trim is achieved. Once the desired trim is achieved, the screen will return to the
Normal display screen after approximately two seconds from the last trim input. If the In-
crease or Decrease keys are pressed any time during the two seconds, the system will return
to the previous screen in use.
*Note: When Auxiliary Channel 3 function 2P is selected, the two screens above are not
present.
0
TRIM
THC
STS
0
TRIM
– –
Steering Trim
(page 28)
Throttle Trim
(page 29)
STG
0
RATE
–
Steering Dual-Rate
(Grip Lever B)
(page 30)
BRK
R/B
E P A
0
AUX
0
Brake Travel Adjustment
(Grip Lever A), (page 31)
Only visible when the Auxiliary Channel
3 function “0” has been selected. Refer to
Auxiliary Channel 3 function, page 16,
for clarification.
Auxiliary Channel 3 Trim Adjustment (LN
mode only). Refer to Auxiliary Channel 3
function, page 32, for clarification.
*
*
Only present when Auxiliary function “0” is selected