Allied Telesis AT-MC14 - Manual (Page 19)

9
Chapter 2
Installing the Media Converter
This chapter explains how to install an AT-MC13 and AT-MC14 media
converter on a desktop. To install the media converter in an AT-MCR12
chassis, refer to the AT-MCR12 Installation Guide. This guide can be
downloaded from our web site at www.alliedtelesyn.com.
Verifying Package Contents
Make sure the following items are included in your media converter package.
If any item is missing or damaged, contact your sales representative for
assistance.
q
One AT-MC13 or AT-MC14 Ethernet Media Converter
q
Four protective feet (for desktop use only)
q
External AC/DC power adapter (North America, Continental Europe,
United Kingdom, or Australia)
q
This installation guide
q
Warranty card
Planning the Installation
Be sure to observe the following guidelines when planning the installation of
your media converter.
q
The end-nodes connected to the media converter must operate at 10
Mbps.
q
The end-nodes connected to the ports of the media converter must be
able to operate in the same duplex mode. These units can operate in
either half- or full-duplex mode.
q
Refer to Table 3 for the twisted pair cabling specifications.