Allied Telesis AT-MC303 - Manual (Page 24)

14
Figure 7 12 V DC Receptacle on Rear Panel
7. Verify that the PWR LED lights green.
8. Set the MDI/MDI-X button for the 100Base-TX twisted pair port to the
appropriate setting, as follows:
❑ If the twisted pair port on the media converter will be connected to an
MDI port on an end node (such as on a workstation or server), set the
button to the MDI-X position. (MDI-X is the default position.)
❑
If the twisted pair port on the media converter will be connected to an
MDI-X port on an end node (such as on a hub, switch, or another media
converter), set the switch to the MDI position.
9. Connect a Category 5 or better twisted pair cable to the RJ-45 connector on
the media converter. Connect the other end of the twisted pair cable to the
desired end node.
10. Remove the dust cover from the fiber optic port.
11. Connect the fiber cable to the fiber optic connector on the media converter.
Connect the other end of the cable to the desired end node.
12. Go to the next procedure, “Verifying the Installation”.
12 V D C