Allied Telesis OmniConnect ISDN User Manual
Page 19
OmniConnect ISDN Quick Install Guide
9
Plug the AC power adapter provided with the unit into the correct AC power
source for this adapter. Next connect the DC cable from the adapter into the
OmniConnect DC input.
Verify that the Power LED lights (see LED table).
5. Verify that the Ethernet LEDs light green (see LED table).
For troubleshooting techniques, refer to your Installation Guide.
You are now ready to configure and setup the OmniConnect. To continue, see
“Verify your PC Configuration” on page 10.
LED
Color
State
Description
Power
Green
On
The unit is receiving power, voltage is within the acceptable
range, and the power supply is working.
Off
No power.
Col
Amber
Flashing
The unit is experiencing collisions on the LAN segment. It is
normal for this indicator to flash on occasion
Off
Normal operation.
Ethernet
Green
On
The port is connected to a active 10Base-T repeater or
adapter and the link is active.
Flashing
The port is receiving data packets.
Off
Port is not connected to an active 10Base-T repeater or
adapter.
ISDN Activ-
ity:
B1, B2, D
Green or
Amber
On
The channel is connected to an active ISDN switch.
Flashing
The channel is receiving and transmitting.
Off
The channel is not active.