Allied Telesis OmniConnect ISDN - Manual (Page 16)

Installation
6
To place your LanEdge product, see the steps that follow:
‰ “To wall mount a LanEdge product” on page 6
‰ “To place a single LanEdge product on a desktop” on page 6
‰ “To interlock a group of LanEdge products on a desktop” on page 7
To wall mount a LanEdge product
1. Do not install the rubber feet or bumpers if you are wall mounting the
product. If you previously installed the square rubber bumpers, remove them
using the following step. (The round rubber feet need not be removed.)
‰ To remove the square rubber bumper from the unit:
Place the unit upside down. For each bumper, insert the tip of a small
straight-slot screwdriver between the rubber bumper and the unit casing.
Press down on the screwdriver to pry the bumper off.
2. Prepare the wall by installing two screws (provided) at 9 1/4-inch (23.5 cm)
apart on center.
3. Position the unit onto the screws. Skip to “Connecting the OmniConnect” on
page 8.
To place a single LanEdge product on a desktop
1. Place the unit upside down.
2. Locate the round rubber feet and square rubber bumpers from the accessory
bag. Remove the paper cover from the adhesive and press a rubber foot into
each round receptacle on the bottom of the unit. Remove the paper cover
from the adhesive and press a rubber bumper into each square receptacle on
the bottom of the unit.
3. Put the unit on the desktop. Skip to “Connecting the OmniConnect” on
page 8.