Allied Telesis OmniConnect ISDN - Manual (Page 18)

Installation
8
3. Place the first LanEdge unit on the desktop as the base. If you are installing a
FastPrint Server, place it as the base (bottom) unit, otherwise, place the
OmniConnect as the base unit.
4. Pry off the interlock cap at each corner of the unit: From the side of the unit,
insert the tip of a small straight-slot screwdriver into the opening of the
interlock cap. Press down on the screwdriver to pry the cap off.
5. Place the next unit over the base (stack) and press down on each corner to
snap the units together.
6. Repeat steps 4 and 5 until all units are in the assemblage.
7. Continue with the installation instructions for each product, and then return
to “Connecting the OmniConnect” on page 8.
Connecting the OmniConnect
1. Connect the ISDN cable to the OmniConnect at the rear panel connector. For
the other end,
— On ISDN (U): connect the cable directly to the ISDN line.
— On the ISDN (S/T): connect the cable to an external NT-1 on the
ISDN line.
2. Connect a telephone (optional) to the POTS connector at the rear panel using
a RJ-11 telephone cable (one provided).
3. Connect the Ethernet LAN devices to the OmniConnect at the rear panel
connectors. Use a straight through RJ-45 cable (one provided) to connect to
the PC through a 10 Mbps or 10/100 Mbps Ethernet Network Interface Card
(NIC).
To connect a LAN to the OmniConnect, use a straight through cable to Port 1
and move the MDI switch to the ON position (use a non-conductive [plastic]
object to move the switch through the case access on the bottom of the
OmniConnect). This eliminates the need for a crossover cable.
1RWH
For your convenience, a flexible cable tie at the right rear of the LanEdge
chassis can be used to secure the Ethernet cables.
4. Apply power to the OmniConnect as follows: