Allied Telesis OmniConnect ISDN - Manual (Page 17)

OmniConnect ISDN Quick Install Guide
7
To interlock a group of LanEdge products on a desktop
You can interlock two or more LanEdge products. Interlocking is a physical
placement so that the products occupy only one footprint on the desktop.
Interlocking does not connect the devices in any other way.
If you are installing a FastPrint Server, place it as the base (bottom) unit,
otherwise, place the OmniConnect as the base unit.
1. Select the base unit and place it upside down on a work surface. Locate the
rubber feet and bumpers from the accessory bag. Remove the paper cover
from the adhesive and press a rubber foot into each round receptacle on the
bottom of the unit. Remove the paper cover from the adhesive and press a
rubber bumper into each square receptacle on the bottom of the unit.
2. Place each of the other units upside down on a work surface. Locate the
rubber feet and bumpers from the accessory bag. Do not install the square
rubber bumpers. Remove the paper cover from the adhesive and press a round
rubber foot into each round receptacle on the bottom of the unit.
1RWH
The LanEdge products will not interlock properly if the square rubber
bumpers are installed on the interlocking (upper) unit; install these
bumpers only on the base unit.