Allied Telesis AT-8550SP - Manual (Page 58)

Installation
58
Installing an Optional SFP Module
For the
AT-8550SP
To install an optional SFP module in an AT-8550SP switch, perform the
following procedure:
Note
A SFP module can be hot-swapped; you do not have to power off a
switch to install it.
1. Unpack the SFP module from its shipping container and store the
packaging material in a safe location.
Note
You must use the original shipping material if you need to return
the module to Allied Telesyn.
Warning
A SFP module can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions, such
as wearing an antistatic wrist strap, to avoid damaging the module.
2. Check that the SFP module comes with the items listed below. If
any item is missing or damaged, contact your Allied Telesyn sales
representative for assistance.
❑
One SFP module
❑
Installation Guide
❑
Warranty card
Note
For fiber optic cabling specifications, refer to the SFP Installation
Guide provided with the module.
3. Follow these guidelines to ensure proper performance of your
GBIC:
❑
SFP modules are static sensitive. To prevent Electrostatic
Discharge (ESD) damage, follow your normal board and
component handling procedures.
❑
SFP modules are dust sensitive. Do not remove the dust cover
from the port until you are ready to attach the fiber optic
cable.